'''Configuring barcode Scanner'''

As at 27/04/06, this scanner comes pre-configured to scan EAN8, EAN-13, Code 39 and Code 128 barcodes.

The ability to scan Interleaved 2 of 5 and Code 93 barcodes is disabled by default.To enable the Interleaved 2 of 5 barcode scanning,

 1. Print out a copy of page "5-91" (167) from the instruction manual.
 1. Scan the "START" barcode
 1. Scan the "Enable Interleave 2 of 5" barcode
 1. Scan the "END" barcode
To enable the Code 93 barcode scanning,

 1. Print out a copy of page "5-123" (199) from the instruction manual.
 1. Scan the "START" barcode
 1. Scan the "Enable Code 93" barcode
 1. Scan the "END" barcode
As at 09/03/07, this scanner will pre-pend a "Code ID" to the output. You will need to turn this off for each of the individual barcode symbologies. To disable the Code ID,

 1. Print off the B-1 (283) from the instruction manual
 1. Print off the "Code ID Selection" barcode page for the appropriate symbology from manual. (Print 5-38,5-85,5-95,5-26)
 1. Scan the "START" barcode
 1. Scan the "Set <symbology> Code ID Characters" barcode (page 283)
 1. Scan the 0 barcode from the Alpha-numeric Pad
 1. Scan the 0 barcode again from the Alpha-numeric Pad
 1. Scan the "SET" barcode
 1. Scan the "END" barcode
'''To fix UPC-A , 12 digit problem of UPC-A.'''

 1. Print 5-3
 1. Scan - start>>don't send checksum>>end
'''Test scanner now'''

 1. Print page F-1
 1. open notepad
 1. Scan EAN-13, Interleaved 2 of 5, Code 128, code 39, upc-A ( forget about codabar and industrial code 2 of 5)
If scan printout number or character same as in sample symbols (f-1), it pass if not redo it.

Instruction manual (PDF): [[attachment:R44-2467A.pdf]]