Updating CCPDE program for Denso

The CCPDE program is a program that runs in BHT BASIC, the source file resides in the std/pde directory called ccpde.src.

There is a BHT BASIC compiler, (30 day trial period), located in the knowledge database hardware/pde/denso/bhtdev4t/BASIC/setup.exe. Need to remember to compile program as a BASIC 3.6 and to turn off option to causes errors for undefined variables. Other wise just refer to the manual – also located in the knowledge database. Once compiled this should create a ccpde.pd3 file.

To download the program onto the PDE Unit hold down SF, 1 and PW keys at the same time to get the System Menu.

You may need to setup the communication setting of the PDE unit first.

• 4:SET SYSTEM

  • -> 5:COMMUNICATIONS

    • -> 2:CONNECTOR

      • -> 1:PARAMETER - should be set to

        • 1:TRANSMIT SPEED : 19200
        • 2:PARITY BIT: N
        • 3:DATA 8
        • 4:STOP 1

    • -> 3:COM PORT

      • 1:BASIC – Connector
      • 2:SYSTEM MODE – Connector

    • -> 4:PROTOCAL TYPE

      • 2:BHT-IR Protocol

To download the CCPDE program press 2:DOWNLOAD -> 1:FILE and then on the PC send the CCPDE.PD3 file using TSR-tu3a (located in knowledge database) transfer Utility (don’t forget to set the communication Parameters to 19200,N,8,1).

After the program is downloaded you could call 1:EXECUTE PROGRAM then CCPDE.PD3 or just turn the unit off and back on again will start the CCPDE program giving the following Menu.

• 1.COLLECT
• 2.COLLECT COUNT = 1
• 3.UPLOAD COUNTS
• 4.DOWNLOAD MASTERFILE
• 5.DELETE MENU

• ["CategoryPDE"]